Dollar Tree Snowman Wreath for Winter

This post may contain affiliate links. We may receive a small commission if you click and purchase something.

Sharing is caring!

This Dollar Tree snowman wreath is perfect for winter or the holidays. Welcome guests into your home with this easy DIY Dollar Tree wreath!

Earlier, we shared a cute grapevine holiday wreath that was super cute. This snowman wreath for winter has to be one of my favorites though. It’s so cute and you can use it for either the holidays or as a general wreath for winter.

It’s also affordable to make and we are all about being budget-friendly here! With a few supplies from Dollar Tree, this snowman wreath for winter comes together easily. Be sure to also check out this adorable snowman ornament made from a mason jar lid!

Dollar Tree Snowman Wreath for Winter

Dollar Tree Snowman Wreath for Winter

How To Make a Snowman Wreath from Dollar Tree Supplies

Supplies needed:

As mentioned above, all of the supplies were purchased at Dollar Tree. However, if your local store doesn’t carry these supplies, other craft stores should.

  • Dollar Tree Snowman Shaped Wreath
  • Scissors
  • Dollar Tree Hat (This one uses the brown/tan striped hat but you can use any style/color)
  • Dollar Tree Nautical Rope
  • Hot Glue Gun
  • Dollar Tree White Faux Fur Pillow
  • Dollar Tree Red Holiday Bow (if you want to change the bow or the color, you can)

How to make this cute winter snowman wreath:

Start by adding a line of hot glue to the insides of the snowman wreath. The large circle will be used on the bottom and the small circle on top.

When going around the circle, make sure to add hot glue to the bars that meet in the middle to hold the form together. Wrap the nautical rope around the circles using hot glue to keep it in place.

winter snowman wreath

Complete this process until both circles’ outer rings are covered with the nautical rope. Cut the end with scissors and then add some hot glue to secure it down.

winter snowman wreath

Cut the faux fur pillow on 3 sides leaving one side attached.

Cut a large enough section of the faux pillow to cover the bottom circle. Using the hot glue gun attached the pillow to the backside of the snowman wreath form. You might need to stretch it across the center part to fit.

dollar tree snowman wreath

Trim the edges of the pillow off. Repeat the same process for the top circle.

Apply a dab of hot glue to the back of the red bow and place it where the two circles meet.

Place the winter hat over where the hat section is. If you want to be sure it is secure, you can use a dab of hot glue to glue the hat onto the wreath.

Hang it on the door or use it as a decoration for the winter season. You can also use it for the holidays!

Dollar Tree Snowman Wreath for Winter

This Dollar Tree snowman wreath is perfect for winter or the holidays. Welcome guests into your home with this easy DIY Dollar Tree wreath!
Active Time20 mins
Total Time20 mins
Cost: $10

Materials

  • Dollar Tree Snowman Shaped Wreath
  • Scissors
  • Dollar Tree Hat (This one uses the brown/tan striped hat but you can use any style/color)
  • Dollar Tree Nautical Rope
  • Hot Glue Gun
  • Dollar Tree White Faux Fur Pillow
  • Dollar Tree Red Holiday Bow (if you want to change the bow or the color, you can)

Instructions

  • Start by adding a line of hot glue to the insides of the snowman wreath. The large circle will be used on the bottom and the small circle on top.
  • When going around the circle, make sure to add hot glue to the bars that meet in the middle to hold the form together. Wrap the nautical rope around the circles using hot glue to keep it in place.
  • Complete this process until both circles’ outer rings are covered with the nautical rope. Cut the end with scissors and then add some hot glue to secure it down.
  • Cut the faux fur pillow on 3 sides leaving one side attached.
  • Cut a large enough section of the faux pillow to cover the bottom circle. Using the hot glue gun attached the pillow to the backside of the snowman wreath form. You might need to stretch it across the center part to fit.
  • Trim the edges of the pillow off. Repeat the same process for the top circle.
  • Apply a dab of hot glue to the back of the red bow and place it where the two circles meet.
  • Place the winter hat over where the hat section is. If you want to be sure it is secure, you can use a dab of hot glue to glue the hat onto the wreath.

Sharing is caring!

Similar Posts

One Comment

Leave a Reply

Your email address will not be published.